Blue Clean 240 Instructions d'exploitation Page 3

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 12
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 2
Operating Instructions and Parts List AR240
3
www.arnorthamerica.com
oPeration
1. Pull trigger on gun.
2. Turn the “ON/OFF” switch to
“ON”.
3. Release trigger. The pressure
washer motor will stop running.
4. To spray again, pull trigger and
motor and pump will restart.
Note: Occasionally the motor may
run for a short time to bring fresh,
cool water into the pump even if
the trigger is released. This is part
of normal operation and will not
damage the unit.
Always turn
the “ON/OFF”
switch to “OFF” then trigger gun
to release hose pressure before
unplugging the power cord.
Risk of equipment
damage. Always
make sure the “ON/OFF” switch
on the unit is “OFF” and unit is
unplugged prior to storage.
Risk of Injection.
Unit will start
spraying when trigger is squeezed
if “ON/OFF” switch is in “ON”
position. Always point gun in a
safe direction.
Save These Instructions
When using this product, basic
precautions should always be
followed, including the following:
1. Read all instructions before
iMPortant Safety inStrUctionS
using the product.
2. Always disconnect power
before disassembling or
repairing the unit.
3. Follow all safety codes as well
as the Occupational Safety and
Health Act (OSHA).
4. Ensure safety devices are
operating properly before each
use. DO NOT remove or modify
any part of the gun or unit.
5. Know how to stop this product
and bleed pressure quickly. Be
thoroughly familiar with the
controls.
6. Stay alert - watch what you are
doing.
7. Do not operate the product
when fatigued or under the
influence of alcohol or drugs.
8. Keep operation area clear of all
persons.
9. Do not overreach or stand on
unstable support. Keep good
footing and balance at all
times.
10. Follow the maintenance
instructions specified in the
manual.
11. This product is provided with a
ground fault circuit interrupter,
GFCI, be sure to inspect cord
and GFCI prior to use. Any
repair or replacement of the
power cord must be performed
by a qualified (licensed or
certified) electrical technician.
12. Never use an extension cord
with this product.
13. The power cord on this product
contains chemicals, including
lead, known to the State of
California to cause [cancer
and] birth defects or other
reproductive harm. Wash
hands after handling.
Vue de la page 2
1 2 3 4 5 6 7 8 ... 11 12

Commentaires sur ces manuels

Pas de commentaire