Blue Clean 240 Instructions d'exploitation télécharger pdf (Page 6)

Operating Instructions and Parts List AR240

6

www.arnorthamerica.com

• NEVER allow the unit to run

with the trigger release (off)

for more than one (1) minute.

Resulting heat buildup will

damage pump.

• Pressure washer is not meant

to pump hot water. NEVER

connect it to a hot water supply

as it will signiﬁcantly reduce the

life of the pump.

• NEVER store the pressure

washer outdoors or where it

could freeze. The pump will be

seriously damaged.

• Release trigger when changing

from high to low pressure

modes. Failure to do so could

result in damage.

Keep hose away

from sharp

objects. Bursting hoses may cause

injury. Examine hoses regularly

and replace if damaged. Do not

attempt to mend a damaged hose.

1. Attach swivel adapter to pump

water inlet, if not already

attached. Notice the swivel

adapter is marked with the

words pump and hose. Make

sure to connect pump side of

the adapter to the pump water

inlet to prevent damage to the

threads.

2. Attach garden hose to swivel

adapter side marked hose.

3. The spray gun should be locked

into the “OFF” position by

locating the safety trigger

lock just above the trigger of

the gun. Activate the lock by

holding the gun and push the

lock from left to right. Squeeze

trigger to make sure the trigger

does not move. The safety

trigger lock should be locked at

all times when pressure washer

is not in use.

1. Plug the power cord into a

grounded 120V outlet and

press the reset button as shown

below.

2. THIS MUST BE DONE EACH

TIME THE UNIT IS PLUGGED IN

AN OUTLET.

PoWer cord

SerVicinG of a doUble-

inSUlated aPPliance (cont)

Garden hoSe connection

inStrUctionS

Pump

Hose

Reset

1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire